/dev/sda smartctl 7.2 2020-12-30 r5155 [x86_64-linux-5.6.15-windowsfx-10-generic] (local build) Copyright (C) 2002-20, Bruce Allen, Christian Franke, www.smartmontools.org === START OF INFORMATION SECTION === Model Family: Seagate Momentus 5400.6 Device Model: ST9320325AS Serial Number: -- LU WWN Device Id: 5 000c50 ... Firmware Version: 0002SDM1 User Capacity: 320,072,933,376 bytes [320 GB] Sector Size: 512 bytes logical/physical Rotation Rate: 5400 rpm Device is: In smartctl database [for details use: -P show] ATA Version is: ATA8-ACS T13/1699-D revision 4 SATA Version is: SATA 2.6, 3.0 Gb/s Local Time is: Thu Feb 18 21:35:52 2021 CET SMART support is: Available - device has SMART capability. SMART support is: Enabled AAM feature is: Unavailable APM level is: 254 (maximum performance) Rd look-ahead is: Enabled Write cache is: Enabled DSN feature is: Unavailable ATA Security is: Disabled, frozen [SEC2] Wt Cache Reorder: Unknown === START OF READ SMART DATA SECTION === SMART overall-health self-assessment test result: PASSED General SMART Values: Offline data collection status: (0x82) Offline data collection activity was completed without error. Auto Offline Data Collection: Enabled. Self-test execution status: ( 0) The previous self-test routine completed without error or no self-test has ever been run. Total time to complete Offline data collection: ( 0) seconds. Offline data collection capabilities: (0x7b) SMART execute Offline immediate. Auto Offline data collection on/off support. Suspend Offline collection upon new command. Offline surface scan supported. Self-test supported. Conveyance Self-test supported. Selective Self-test supported. SMART capabilities: (0x0003) Saves SMART data before entering power-saving mode. Supports SMART auto save timer. Error logging capability: (0x01) Error logging supported. General Purpose Logging supported. Short self-test routine recommended polling time: ( 1) minutes. Extended self-test routine recommended polling time: ( 101) minutes. Conveyance self-test routine recommended polling time: ( 2) minutes. SCT capabilities: (0x103b) SCT Status supported. SCT Error Recovery Control supported. SCT Feature Control supported. SCT Data Table supported. SMART Attributes Data Structure revision number: 10 Vendor Specific SMART Attributes with Thresholds: ID# ATTRIBUTE_NAME FLAGS VALUE WORST THRESH FAIL RAW_VALUE 1 Raw_Read_Error_Rate POSR-- 111 099 006 - 30177901 3 Spin_Up_Time PO---- 099 098 000 - 0 4 Start_Stop_Count -O--CK 093 093 020 - 7804 5 Reallocated_Sector_Ct PO--CK 100 100 036 - 6 7 Seek_Error_Rate POSR-- 089 060 030 - 814221420 9 Power_On_Hours -O--CK 055 055 000 - 39475 10 Spin_Retry_Count PO--C- 100 100 097 - 0 12 Power_Cycle_Count -O--CK 093 037 020 - 7801 184 End-to-End_Error -O--CK 100 100 099 - 0 187 Reported_Uncorrect -O--CK 097 097 000 - 3 188 Command_Timeout -O--CK 100 099 000 - 4295032856 189 High_Fly_Writes -O-RCK 100 100 000 - 0 190 Airflow_Temperature_Cel -O---K 067 049 045 - 33 (Min/Max 25/33) 191 G-Sense_Error_Rate -O--CK 100 100 000 - 558 192 Power-Off_Retract_Count -O--CK 100 100 000 - 10 193 Load_Cycle_Count -O--CK 001 001 000 - 567525 194 Temperature_Celsius -O---K 033 051 000 - 33 (0 5 0 0 0) 195 Hardware_ECC_Recovered -O-RC- 051 042 000 - 30177901 197 Current_Pending_Sector -O--C- 100 100 000 - 0 198 Offline_Uncorrectable ----C- 100 100 000 - 0 199 UDMA_CRC_Error_Count -OSRCK 200 200 000 - 0 254 Free_Fall_Sensor -O--CK 100 100 000 - 0 ||||||_ K auto-keep |||||__ C event count ||||___ R error rate |||____ S speed/performance ||_____ O updated online |______ P prefailure warning General Purpose Log Directory Version 1 SMART Log Directory Version 1 [multi-sector log support] Address Access R/W Size Description 0x00 GPL,SL R/O 1 Log Directory 0x01 GPL,SL R/O 1 Summary SMART error log 0x02 GPL,SL R/O 5 Comprehensive SMART error log 0x03 GPL,SL R/O 5 Ext. Comprehensive SMART error log 0x06 GPL,SL R/O 1 SMART self-test log 0x07 GPL,SL R/O 1 Extended self-test log 0x09 GPL,SL R/W 1 Selective self-test log 0x10 GPL,SL R/O 1 NCQ Command Error log 0x11 GPL,SL R/O 1 SATA Phy Event Counters log 0x21 GPL,SL R/O 1 Write stream error log 0x22 GPL,SL R/O 1 Read stream error log 0x80-0x9f GPL,SL R/W 16 Host vendor specific log 0xa1 GPL,SL VS 20 Device vendor specific log 0xa2 GPL VS 2248 Device vendor specific log 0xa8 GPL,SL VS 65 Device vendor specific log 0xa9 GPL,SL VS 1 Device vendor specific log 0xb0 GPL VS 2864 Device vendor specific log 0xbe-0xbf GPL VS 65535 Device vendor specific log 0xe0 GPL,SL R/W 1 SCT Command/Status 0xe1 GPL,SL R/W 1 SCT Data Transfer SMART Extended Comprehensive Error Log Version: 1 (5 sectors) Device Error Count: 2 CR = Command Register FEATR = Features Register COUNT = Count (was: Sector Count) Register LBA_48 = Upper bytes of LBA High/Mid/Low Registers ] ATA-8 LH = LBA High (was: Cylinder High) Register ] LBA LM = LBA Mid (was: Cylinder Low) Register ] Register LL = LBA Low (was: Sector Number) Register ] DV = Device (was: Device/Head) Register DC = Device Control Register ER = Error register ST = Status register Powered_Up_Time is measured from power on, and printed as DDd+hh:mm:SS.sss where DD=days, hh=hours, mm=minutes, SS=sec, and sss=millisec. It "wraps" after 49.710 days. Error 2 [1] occurred at disk power-on lifetime: 4889 hours (203 days + 17 hours) When the command that caused the error occurred, the device was active or idle. After command completion occurred, registers were: ER -- ST COUNT LBA_48 LH LM LL DV DC -- -- -- == -- == == == -- -- -- -- -- 40 -- 51 00 00 00 00 0c a7 1f ee 00 00 Error: UNC at LBA = 0x0ca71fee = 212279278 Commands leading to the command that caused the error were: CR FEATR COUNT LBA_48 LH LM LL DV DC Powered_Up_Time Command/Feature_Name -- == -- == -- == == == -- -- -- -- -- --------------- -------------------- 25 00 00 00 08 00 00 0c a7 1f e8 e0 00 00:38:37.323 READ DMA EXT 25 00 00 00 08 00 00 0c a7 1f e0 e0 00 00:38:37.321 READ DMA EXT 25 00 00 00 08 00 00 0c a7 1f d8 e0 00 00:38:37.321 READ DMA EXT 25 00 00 00 08 00 00 0c a7 1f d0 e0 00 00:38:37.321 READ DMA EXT 25 00 00 00 08 00 00 0c a7 1f c8 e0 00 00:38:37.320 READ DMA EXT Error 1 [0] occurred at disk power-on lifetime: 4889 hours (203 days + 17 hours) When the command that caused the error occurred, the device was active or idle. After command completion occurred, registers were: ER -- ST COUNT LBA_48 LH LM LL DV DC -- -- -- == -- == == == -- -- -- -- -- 40 -- 51 00 00 00 00 0c a7 1f ee 00 00 Error: UNC at LBA = 0x0ca71fee = 212279278 Commands leading to the command that caused the error were: CR FEATR COUNT LBA_48 LH LM LL DV DC Powered_Up_Time Command/Feature_Name -- == -- == -- == == == -- -- -- -- -- --------------- -------------------- 25 00 00 01 00 00 00 0c a7 1f 00 e0 00 00:38:34.725 READ DMA EXT 25 00 00 01 00 00 00 0c a7 1e 00 e0 00 00:38:34.692 READ DMA EXT 35 00 00 00 20 00 00 15 18 a1 80 e0 00 00:38:34.690 WRITE DMA EXT 35 00 00 00 20 00 00 15 af 93 80 e0 00 00:38:34.689 WRITE DMA EXT 25 00 00 00 20 00 00 00 58 71 00 e0 00 00:38:34.689 READ DMA EXT SMART Extended Self-test Log Version: 1 (1 sectors) No self-tests have been logged. [To run self-tests, use: smartctl -t] SMART Selective self-test log data structure revision number 1 SPAN MIN_LBA MAX_LBA CURRENT_TEST_STATUS 1 0 0 Not_testing 2 0 0 Not_testing 3 0 0 Not_testing 4 0 0 Not_testing 5 0 0 Not_testing Selective self-test flags (0x0): After scanning selected spans, do NOT read-scan remainder of disk. If Selective self-test is pending on power-up, resume after 0 minute delay. SCT Status Version: 3 SCT Version (vendor specific): 522 (0x020a) Device State: Active (0) Current Temperature: 33 Celsius Power Cycle Min/Max Temperature: 25/33 Celsius Lifetime Min/Max Temperature: 5/51 Celsius Under/Over Temperature Limit Count: 0/185 SCT Temperature History Version: 2 Temperature Sampling Period: 1 minute Temperature Logging Interval: 1 minute Min/Max recommended Temperature: 0/ 0 Celsius Min/Max Temperature Limit: 0/ 0 Celsius Temperature History Size (Index): 128 (98) Index Estimated Time Temperature Celsius 99 2021-02-18 19:28 25 ****** 100 2021-02-18 19:29 26 ******* 101 2021-02-18 19:30 25 ****** ... ..( 3 skipped). .. ****** 105 2021-02-18 19:34 25 ****** 106 2021-02-18 19:35 26 ******* ... ..( 16 skipped). .. ******* 123 2021-02-18 19:52 26 ******* 124 2021-02-18 19:53 27 ******** 125 2021-02-18 19:54 26 ******* ... ..( 2 skipped). .. ******* 0 2021-02-18 19:57 26 ******* 1 2021-02-18 19:58 27 ******** ... ..( 7 skipped). .. ******** 9 2021-02-18 20:06 27 ******** 10 2021-02-18 20:07 28 ********* ... ..( 7 skipped). .. ********* 18 2021-02-18 20:15 28 ********* 19 2021-02-18 20:16 29 ********** ... ..( 6 skipped). .. ********** 26 2021-02-18 20:23 29 ********** 27 2021-02-18 20:24 30 *********** ... ..( 12 skipped). .. *********** 40 2021-02-18 20:37 30 *********** 41 2021-02-18 20:38 31 ************ ... ..( 31 skipped). .. ************ 73 2021-02-18 21:10 31 ************ 74 2021-02-18 21:11 32 ************* ... ..( 18 skipped). .. ************* 93 2021-02-18 21:30 32 ************* 94 2021-02-18 21:31 33 ************** ... ..( 3 skipped). .. ************** 98 2021-02-18 21:35 33 ************** SCT Error Recovery Control: Read: Disabled Write: Disabled Device Statistics (GP/SMART Log 0x04) not supported Pending Defects log (GP Log 0x0c) not supported SATA Phy Event Counters (GP Log 0x11) ID Size Value Description 0x000a 2 3 Device-to-host register FISes sent due to a COMRESET 0x0001 2 0 Command failed due to ICRC error 0x0003 2 0 R_ERR response for device-to-host data FIS 0x0004 2 0 R_ERR response for host-to-device data FIS 0x0006 2 0 R_ERR response for device-to-host non-data FIS 0x0007 2 0 R_ERR response for host-to-device non-data FIS