/dev/sda smartctl 7.1 2019-12-30 r5022 [x86_64-linux-5.4.0-39-generic] (local build) Copyright (C) 2002-19, Bruce Allen, Christian Franke, www.smartmontools.org === START OF INFORMATION SECTION === Model Family: SAMSUNG SpinPoint P80 Device Model: SAMSUNG SP1614C Serial Number: -- Firmware Version: SW100-34 User Capacity: 160,041,885,696 bytes [160 GB] Sector Size: 512 bytes logical/physical Device is: In smartctl database [for details use: -P show] ATA Version is: ATA/ATAPI-7 T13/1532D revision 0 Local Time is: Sun Jun 28 12:44:55 2020 CEST SMART support is: Available - device has SMART capability. SMART support is: Enabled AAM feature is: Disabled APM feature is: Unavailable Rd look-ahead is: Enabled Write cache is: Enabled DSN feature is: Unavailable ATA Security is: Disabled, frozen [SEC2] Wt Cache Reorder: Unavailable === START OF READ SMART DATA SECTION === SMART overall-health self-assessment test result: PASSED General SMART Values: Offline data collection status: (0x00) Offline data collection activity was never started. Auto Offline Data Collection: Disabled. Self-test execution status: ( 0) The previous self-test routine completed without error or no self-test has ever been run. Total time to complete Offline data collection: ( 6000) seconds. Offline data collection capabilities: (0x1b) SMART execute Offline immediate. Auto Offline data collection on/off support. Suspend Offline collection upon new command. Offline surface scan supported. Self-test supported. No Conveyance Self-test supported. No Selective Self-test supported. SMART capabilities: (0x0003) Saves SMART data before entering power-saving mode. Supports SMART auto save timer. Error logging capability: (0x01) Error logging supported. No General Purpose Logging support. Short self-test routine recommended polling time: ( 1) minutes. Extended self-test routine recommended polling time: ( 100) minutes. SMART Attributes Data Structure revision number: 16 Vendor Specific SMART Attributes with Thresholds: ID# ATTRIBUTE_NAME FLAGS VALUE WORST THRESH FAIL RAW_VALUE 1 Raw_Read_Error_Rate POSR-- 100 096 051 - 6 3 Spin_Up_Time POS--- 100 100 025 - 5568 4 Start_Stop_Count -O--CK 090 090 000 - 10740 5 Reallocated_Sector_Ct PO--CK 100 100 011 - 0 7 Seek_Error_Rate POSR-- 100 100 051 - 0 8 Seek_Time_Performance P-S--K 100 100 015 - 0 9 Power_On_Half_Minutes -O--CK 095 095 000 - 25478h+25m 10 Spin_Retry_Count PO--CK 100 100 051 - 1 11 Calibration_Retry_Count -O--C- 100 100 000 - 0 12 Power_Cycle_Count -O--CK 096 096 000 - 4486 194 Temperature_Celsius -O---K 133 058 000 - 35 195 Hardware_ECC_Recovered -O-RC- 100 100 000 - 15345440 196 Reallocated_Event_Count -O--CK 092 092 000 - 18 197 Current_Pending_Sector -O--C- 100 100 000 - 0 198 Total_Offl_Uncorrectabl ----CK 100 100 000 - 0 199 UDMA_CRC_Error_Count -OSRCK 200 200 000 - 0 200 Multi_Zone_Error_Rate -O-R-- 100 100 051 - 0 201 Soft_Read_Error_Rate -O-R-- 100 100 051 - 5 ||||||_ K auto-keep |||||__ C event count ||||___ R error rate |||____ S speed/performance ||_____ O updated online |______ P prefailure warning General Purpose Log Directory not supported SMART Log Directory Version 1 [multi-sector log support] Address Access R/W Size Description 0x00 SL R/O 1 Log Directory 0x01 SL R/O 1 Summary SMART error log 0x02 SL R/O 2 Comprehensive SMART error log 0x06 SL R/O 2 SMART self-test log 0x80-0x9f SL R/W 16 Host vendor specific log SMART Extended Comprehensive Error Log (GP Log 0x03) not supported SMART Error Log Version: 1 ATA Error Count: 3521 (device log contains only the most recent five errors) CR = Command Register [HEX] FR = Features Register [HEX] SC = Sector Count Register [HEX] SN = Sector Number Register [HEX] CL = Cylinder Low Register [HEX] CH = Cylinder High Register [HEX] DH = Device/Head Register [HEX] DC = Device Command Register [HEX] ER = Error register [HEX] ST = Status register [HEX] Powered_Up_Time is measured from power on, and printed as DDd+hh:mm:SS.sss where DD=days, hh=hours, mm=minutes, SS=sec, and sss=millisec. It "wraps" after 49.710 days. Error 3521 occurred at disk power-on lifetime: 25478 hours (1061 days + 14 hours) When the command that caused the error occurred, the device was active or idle. After command completion occurred, registers were: ER ST SC SN CL CH DH -- -- -- -- -- -- -- 04 51 01 00 00 00 e0 Commands leading to the command that caused the error were: CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name -- -- -- -- -- -- -- -- ---------------- -------------------- f9 01 01 00 00 00 e0 00 03:47:00.438 SET MAX SET PASSWORD [OBS-ACS-3] f5 00 00 00 00 00 e0 00 03:47:00.438 SECURITY FREEZE LOCK ec 00 00 00 00 00 e0 00 03:47:00.438 IDENTIFY DEVICE 00 00 01 01 00 00 a0 00 03:47:00.438 NOP [Abort queued commands] ef 03 46 00 00 00 e0 00 03:46:20.250 SET FEATURES [Set transfer mode] Error 3520 occurred at disk power-on lifetime: 25478 hours (1061 days + 14 hours) When the command that caused the error occurred, the device was active or idle. After command completion occurred, registers were: ER ST SC SN CL CH DH -- -- -- -- -- -- -- 04 51 01 00 00 00 e0 Commands leading to the command that caused the error were: CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name -- -- -- -- -- -- -- -- ---------------- -------------------- f9 01 01 00 00 00 e0 00 03:46:20.188 SET MAX SET PASSWORD [OBS-ACS-3] f5 00 00 00 00 00 e0 00 03:46:20.188 SECURITY FREEZE LOCK ec 00 00 00 00 00 e0 00 03:46:20.188 IDENTIFY DEVICE 00 00 01 01 00 00 a0 00 03:46:20.188 NOP [Abort queued commands] 00 00 01 01 00 00 a0 00 03:46:20.188 NOP [Abort queued commands] Error 3519 occurred at disk power-on lifetime: 25477 hours (1061 days + 13 hours) When the command that caused the error occurred, the device was active or idle. After command completion occurred, registers were: ER ST SC SN CL CH DH -- -- -- -- -- -- -- 04 51 01 00 00 00 e0 Commands leading to the command that caused the error were: CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name -- -- -- -- -- -- -- -- ---------------- -------------------- f9 01 01 00 00 00 e0 00 03:10:32.500 SET MAX SET PASSWORD [OBS-ACS-3] f5 00 00 00 00 00 e0 00 03:10:32.500 SECURITY FREEZE LOCK ec 00 00 00 00 00 e0 00 03:10:32.500 IDENTIFY DEVICE 00 00 01 01 00 00 a0 00 03:10:32.438 NOP [Abort queued commands] ef 03 46 00 00 00 e0 00 03:10:17.875 SET FEATURES [Set transfer mode] Error 3518 occurred at disk power-on lifetime: 25477 hours (1061 days + 13 hours) When the command that caused the error occurred, the device was active or idle. After command completion occurred, registers were: ER ST SC SN CL CH DH -- -- -- -- -- -- -- 04 51 01 00 00 00 e0 Commands leading to the command that caused the error were: CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name -- -- -- -- -- -- -- -- ---------------- -------------------- f9 01 01 00 00 00 e0 00 03:10:17.875 SET MAX SET PASSWORD [OBS-ACS-3] f5 00 00 00 00 00 e0 00 03:10:17.813 SECURITY FREEZE LOCK ec 00 00 00 00 00 e0 00 03:10:17.813 IDENTIFY DEVICE 00 00 01 01 00 00 a0 00 03:10:17.813 NOP [Abort queued commands] 00 00 01 01 00 00 a0 00 03:10:17.813 NOP [Abort queued commands] Error 3517 occurred at disk power-on lifetime: 25477 hours (1061 days + 13 hours) When the command that caused the error occurred, the device was active or idle. After command completion occurred, registers were: ER ST SC SN CL CH DH -- -- -- -- -- -- -- 04 51 01 00 00 00 e0 Commands leading to the command that caused the error were: CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name -- -- -- -- -- -- -- -- ---------------- -------------------- f9 01 01 00 00 00 e0 00 02:22:25.438 SET MAX SET PASSWORD [OBS-ACS-3] f5 00 00 00 00 00 e0 00 02:22:25.438 SECURITY FREEZE LOCK ec 00 00 00 00 00 e0 00 02:22:25.438 IDENTIFY DEVICE 00 00 01 01 00 00 a0 00 02:22:25.438 NOP [Abort queued commands] ef 03 46 00 00 00 e0 00 02:21:32.313 SET FEATURES [Set transfer mode] SMART Extended Self-test Log (GP Log 0x07) not supported SMART Self-test log structure revision number 1 No self-tests have been logged. [To run self-tests, use: smartctl -t] Selective Self-tests/Logging not supported SCT Commands not supported Device Statistics (GP/SMART Log 0x04) not supported Pending Defects log (GP Log 0x0c) not supported SATA Phy Event Counters (GP Log 0x11) not supported