/dev/sda smartctl 7.2 2020-12-30 r5155 [x86_64-linux-5.10.74-generic-2rosa2021.1-x86_64] (local build) Copyright (C) 2002-20, Bruce Allen, Christian Franke, www.smartmontools.org === START OF INFORMATION SECTION === Model Family: Hitachi/HGST Travelstar 5K750 Device Model: Hitachi HTS547550A9E384 Serial Number: -- LU WWN Device Id: 5 000cca ... Firmware Version: JE3OA60A User Capacity: 500,107,862,016 bytes [500 GB] Sector Sizes: 512 bytes logical, 4096 bytes physical Rotation Rate: 5400 rpm Form Factor: 2.5 inches Device is: In smartctl database [for details use: -P show] ATA Version is: ATA8-ACS T13/1699-D revision 6 SATA Version is: SATA 2.6, 3.0 Gb/s Local Time is: Thu Mar 10 18:10:05 2022 MSK SMART support is: Available - device has SMART capability. SMART support is: Enabled AAM feature is: Unavailable APM level is: 128 (minimum power consumption without standby) Rd look-ahead is: Enabled Write cache is: Enabled DSN feature is: Unavailable ATA Security is: Disabled, NOT FROZEN [SEC1] Wt Cache Reorder: Enabled === START OF READ SMART DATA SECTION === SMART overall-health self-assessment test result: PASSED General SMART Values: Offline data collection status: (0x82) Offline data collection activity was completed without error. Auto Offline Data Collection: Enabled. Self-test execution status: ( 0) The previous self-test routine completed without error or no self-test has ever been run. Total time to complete Offline data collection: ( 45) seconds. Offline data collection capabilities: (0x5b) SMART execute Offline immediate. Auto Offline data collection on/off support. Suspend Offline collection upon new command. Offline surface scan supported. Self-test supported. No Conveyance Self-test supported. Selective Self-test supported. SMART capabilities: (0x0003) Saves SMART data before entering power-saving mode. Supports SMART auto save timer. Error logging capability: (0x01) Error logging supported. General Purpose Logging supported. Short self-test routine recommended polling time: ( 2) minutes. Extended self-test routine recommended polling time: ( 133) minutes. SCT capabilities: (0x003d) SCT Status supported. SCT Error Recovery Control supported. SCT Feature Control supported. SCT Data Table supported. SMART Attributes Data Structure revision number: 16 Vendor Specific SMART Attributes with Thresholds: ID# ATTRIBUTE_NAME FLAGS VALUE WORST THRESH FAIL RAW_VALUE 1 Raw_Read_Error_Rate PO-R-- 100 100 062 - 0 2 Throughput_Performance P-S--- 198 198 040 - 142 3 Spin_Up_Time POS--- 178 178 033 - 1 4 Start_Stop_Count -O--C- 093 093 000 - 11104 5 Reallocated_Sector_Ct PO--CK 100 100 005 - 0 7 Seek_Error_Rate PO-R-- 100 100 067 - 0 8 Seek_Time_Performance P-S--- 115 115 040 - 34 9 Power_On_Hours -O--C- 014 014 000 - 37982 10 Spin_Retry_Count PO--C- 100 100 060 - 0 12 Power_Cycle_Count -O--CK 093 093 000 - 11091 191 G-Sense_Error_Rate -O-R-- 100 100 000 - 0 192 Power-Off_Retract_Count -O--CK 092 092 000 - 1706 193 Load_Cycle_Count -O--C- 001 001 000 - 1534371 194 Temperature_Celsius -O---- 214 214 000 - 28 (Min/Max 12/51) 196 Reallocated_Event_Count -O--CK 100 100 000 - 0 197 Current_Pending_Sector -O---K 100 100 000 - 0 198 Offline_Uncorrectable ---R-- 100 100 000 - 0 199 UDMA_CRC_Error_Count -O-R-- 200 200 000 - 0 223 Load_Retry_Count -O-R-- 100 100 000 - 0 ||||||_ K auto-keep |||||__ C event count ||||___ R error rate |||____ S speed/performance ||_____ O updated online |______ P prefailure warning General Purpose Log Directory Version 1 SMART Log Directory Version 1 [multi-sector log support] Address Access R/W Size Description 0x00 GPL,SL R/O 1 Log Directory 0x01 SL R/O 1 Summary SMART error log 0x02 SL R/O 1 Comprehensive SMART error log 0x03 GPL R/O 1 Ext. Comprehensive SMART error log 0x06 SL R/O 1 SMART self-test log 0x07 GPL R/O 1 Extended self-test log 0x09 SL R/W 1 Selective self-test log 0x10 GPL R/O 1 NCQ Command Error log 0x11 GPL R/O 1 SATA Phy Event Counters log 0x80-0x9f GPL,SL R/W 16 Host vendor specific log 0xe0 GPL,SL R/W 1 SCT Command/Status 0xe1 GPL,SL R/W 1 SCT Data Transfer SMART Extended Comprehensive Error Log Version: 1 (1 sectors) No Errors Logged SMART Extended Self-test Log Version: 1 (1 sectors) Num Test_Description Status Remaining LifeTime(hours) LBA_of_first_error # 1 Extended offline Completed without error 00% 33941 - # 2 Extended offline Completed without error 00% 33826 - # 3 Extended offline Completed without error 00% 33668 - # 4 Extended offline Interrupted (host reset) 90% 33578 - # 5 Extended offline Completed without error 00% 33375 - # 6 Extended offline Completed without error 00% 33210 - # 7 Extended offline Completed without error 00% 22044 - # 8 Extended offline Completed without error 00% 21867 - # 9 Extended offline Completed without error 00% 21775 - #10 Extended offline Completed without error 00% 21687 - #11 Extended offline Completed without error 00% 21456 - #12 Short offline Completed without error 00% 20652 - #13 Extended offline Completed without error 00% 19724 - #14 Extended offline Completed without error 00% 17714 - #15 Extended offline Completed without error 00% 17620 - #16 Extended offline Completed without error 00% 17288 - #17 Extended offline Completed without error 00% 17165 - #18 Extended offline Completed without error 00% 16566 - #19 Extended offline Completed without error 00% 16276 - SMART Selective self-test log data structure revision number 1 SPAN MIN_LBA MAX_LBA CURRENT_TEST_STATUS 1 0 0 Not_testing 2 0 0 Not_testing 3 0 0 Not_testing 4 0 0 Not_testing 5 0 0 Not_testing Selective self-test flags (0x0): After scanning selected spans, do NOT read-scan remainder of disk. If Selective self-test is pending on power-up, resume after 0 minute delay. SCT Status Version: 3 SCT Version (vendor specific): 256 (0x0100) Device State: Active (0) Current Temperature: 28 Celsius Power Cycle Min/Max Temperature: 22/33 Celsius Lifetime Min/Max Temperature: 12/51 Celsius Specified Max Operating Temperature: 33 Celsius Under/Over Temperature Limit Count: 0/0 SCT Temperature History Version: 2 Temperature Sampling Period: 1 minute Temperature Logging Interval: 1 minute Min/Max recommended Temperature: 0/60 Celsius Min/Max Temperature Limit: -40/65 Celsius Temperature History Size (Index): 128 (41) Index Estimated Time Temperature Celsius 42 2022-03-10 16:03 32 ************* ... ..( 20 skipped). .. ************* 63 2022-03-10 16:24 32 ************* 64 2022-03-10 16:25 31 ************ 65 2022-03-10 16:26 32 ************* 66 2022-03-10 16:27 31 ************ 67 2022-03-10 16:28 31 ************ 68 2022-03-10 16:29 32 ************* ... ..( 7 skipped). .. ************* 76 2022-03-10 16:37 32 ************* 77 2022-03-10 16:38 31 ************ ... ..( 10 skipped). .. ************ 88 2022-03-10 16:49 31 ************ 89 2022-03-10 16:50 32 ************* ... ..( 19 skipped). .. ************* 109 2022-03-10 17:10 32 ************* 110 2022-03-10 17:11 33 ************** 111 2022-03-10 17:12 33 ************** 112 2022-03-10 17:13 32 ************* 113 2022-03-10 17:14 32 ************* 114 2022-03-10 17:15 33 ************** ... ..( 6 skipped). .. ************** 121 2022-03-10 17:22 33 ************** 122 2022-03-10 17:23 32 ************* ... ..( 6 skipped). .. ************* 1 2022-03-10 17:30 32 ************* 2 2022-03-10 17:31 31 ************ ... ..( 3 skipped). .. ************ 6 2022-03-10 17:35 31 ************ 7 2022-03-10 17:36 30 *********** ... ..( 5 skipped). .. *********** 13 2022-03-10 17:42 30 *********** 14 2022-03-10 17:43 29 ********** ... ..( 18 skipped). .. ********** 33 2022-03-10 18:02 29 ********** 34 2022-03-10 18:03 28 ********* 35 2022-03-10 18:04 29 ********** ... ..( 2 skipped). .. ********** 38 2022-03-10 18:07 29 ********** 39 2022-03-10 18:08 28 ********* 40 2022-03-10 18:09 28 ********* 41 2022-03-10 18:10 28 ********* SCT Error Recovery Control: Read: Disabled Write: Disabled Device Statistics (GP/SMART Log 0x04) not supported Pending Defects log (GP Log 0x0c) not supported SATA Phy Event Counters (GP Log 0x11) ID Size Value Description 0x0001 2 0 Command failed due to ICRC error 0x0002 2 0 R_ERR response for data FIS 0x0003 2 0 R_ERR response for device-to-host data FIS 0x0004 2 0 R_ERR response for host-to-device data FIS 0x0005 2 0 R_ERR response for non-data FIS 0x0006 2 0 R_ERR response for device-to-host non-data FIS 0x0007 2 0 R_ERR response for host-to-device non-data FIS 0x0009 2 65535+ Transition from drive PhyRdy to drive PhyNRdy 0x000a 2 19 Device-to-host register FISes sent due to a COMRESET 0x000b 2 0 CRC errors within host-to-device FIS 0x000d 2 0 Non-CRC errors within host-to-device FIS