Wiphy phy0 max # scan SSIDs: 4 max scan IEs length: 2285 bytes Retry short limit: 7 Retry long limit: 4 Coverage class: 0 (up to 0m) Device supports RSN-IBSS. Supported Ciphers: * WEP40 (00-0f-ac:1) * WEP104 (00-0f-ac:5) * TKIP (00-0f-ac:2) * CCMP (00-0f-ac:4) * 00-0f-ac:10 * GCMP (00-0f-ac:8) * 00-0f-ac:9 Available Antennas: TX 0 RX 0 Supported interface modes: * IBSS * managed * monitor Band 1: Bitrates (non-HT): * 1.0 Mbps * 2.0 Mbps (short preamble supported) * 5.5 Mbps (short preamble supported) * 11.0 Mbps (short preamble supported) * 6.0 Mbps * 9.0 Mbps * 12.0 Mbps * 18.0 Mbps * 24.0 Mbps * 36.0 Mbps * 48.0 Mbps * 54.0 Mbps Frequencies: * 2412 MHz [1] (15.0 dBm) * 2417 MHz [2] (15.0 dBm) * 2422 MHz [3] (15.0 dBm) * 2427 MHz [4] (15.0 dBm) * 2432 MHz [5] (15.0 dBm) * 2437 MHz [6] (15.0 dBm) * 2442 MHz [7] (15.0 dBm) * 2447 MHz [8] (15.0 dBm) * 2452 MHz [9] (15.0 dBm) * 2457 MHz [10] (15.0 dBm) * 2462 MHz [11] (15.0 dBm) * 2467 MHz [12] (15.0 dBm) (no IR) * 2472 MHz [13] (15.0 dBm) (no IR) Band 2: Bitrates (non-HT): * 6.0 Mbps * 9.0 Mbps * 12.0 Mbps * 18.0 Mbps * 24.0 Mbps * 36.0 Mbps * 48.0 Mbps * 54.0 Mbps Frequencies: * 5170 MHz [34] (disabled) * 5180 MHz [36] (15.0 dBm) * 5190 MHz [38] (15.0 dBm) (no IR) * 5200 MHz [40] (15.0 dBm) * 5210 MHz [42] (15.0 dBm) (no IR) * 5220 MHz [44] (15.0 dBm) * 5230 MHz [46] (15.0 dBm) (no IR) * 5240 MHz [48] (15.0 dBm) * 5260 MHz [52] (15.0 dBm) (no IR, radar detection) DFS state: usable (for 910 sec) DFS CAC time: 60000 ms * 5280 MHz [56] (15.0 dBm) (no IR, radar detection) DFS state: usable (for 910 sec) DFS CAC time: 60000 ms * 5300 MHz [60] (15.0 dBm) (no IR, radar detection) DFS state: usable (for 910 sec) DFS CAC time: 60000 ms * 5320 MHz [64] (15.0 dBm) (no IR, radar detection) DFS state: usable (for 910 sec) DFS CAC time: 60000 ms * 5500 MHz [100] (16.0 dBm) (no IR, radar detection) DFS state: usable (for 910 sec) DFS CAC time: 60000 ms * 5520 MHz [104] (16.0 dBm) (no IR, radar detection) DFS state: usable (for 910 sec) DFS CAC time: 60000 ms * 5540 MHz [108] (16.0 dBm) (no IR, radar detection) DFS state: usable (for 910 sec) DFS CAC time: 60000 ms * 5560 MHz [112] (16.0 dBm) (no IR, radar detection) DFS state: usable (for 910 sec) DFS CAC time: 60000 ms * 5580 MHz [116] (16.0 dBm) (no IR, radar detection) DFS state: usable (for 910 sec) DFS CAC time: 60000 ms * 5600 MHz [120] (16.0 dBm) (no IR, radar detection) DFS state: usable (for 910 sec) DFS CAC time: 60000 ms * 5620 MHz [124] (16.0 dBm) (no IR, radar detection) DFS state: usable (for 910 sec) DFS CAC time: 60000 ms * 5640 MHz [128] (16.0 dBm) (no IR, radar detection) DFS state: usable (for 910 sec) DFS CAC time: 60000 ms * 5660 MHz [132] (16.0 dBm) (no IR, radar detection) DFS state: usable (for 910 sec) DFS CAC time: 60000 ms * 5680 MHz [136] (16.0 dBm) (no IR, radar detection) DFS state: usable (for 910 sec) DFS CAC time: 60000 ms * 5700 MHz [140] (16.0 dBm) (no IR, radar detection) DFS state: usable (for 910 sec) DFS CAC time: 60000 ms Supported commands: * new_interface * set_interface * new_key * start_ap * new_station * new_mpath * set_mesh_config * set_bss * authenticate * associate * deauthenticate * disassociate * join_ibss * join_mesh * set_tx_bitrate_mask * frame * frame_wait_cancel * set_wiphy_netns * set_channel * set_wds_peer * probe_client * set_noack_map * register_beacons * start_p2p_device * set_mcast_rate * Unknown command (104) * connect * disconnect Supported TX frame types: * IBSS: 0x00 0x10 0x20 0x30 0x40 0x50 0x60 0x70 0x80 0x90 0xa0 0xb0 0xc0 0xd0 0xe0 0xf0 * managed: 0x00 0x10 0x20 0x30 0x40 0x50 0x60 0x70 0x80 0x90 0xa0 0xb0 0xc0 0xd0 0xe0 0xf0 * AP: 0x00 0x10 0x20 0x30 0x40 0x50 0x60 0x70 0x80 0x90 0xa0 0xb0 0xc0 0xd0 0xe0 0xf0 * AP/VLAN: 0x00 0x10 0x20 0x30 0x40 0x50 0x60 0x70 0x80 0x90 0xa0 0xb0 0xc0 0xd0 0xe0 0xf0 * mesh point: 0x00 0x10 0x20 0x30 0x40 0x50 0x60 0x70 0x80 0x90 0xa0 0xb0 0xc0 0xd0 0xe0 0xf0 * P2P-client: 0x00 0x10 0x20 0x30 0x40 0x50 0x60 0x70 0x80 0x90 0xa0 0xb0 0xc0 0xd0 0xe0 0xf0 * P2P-GO: 0x00 0x10 0x20 0x30 0x40 0x50 0x60 0x70 0x80 0x90 0xa0 0xb0 0xc0 0xd0 0xe0 0xf0 * P2P-device: 0x00 0x10 0x20 0x30 0x40 0x50 0x60 0x70 0x80 0x90 0xa0 0xb0 0xc0 0xd0 0xe0 0xf0 Supported RX frame types: * IBSS: 0x40 0xb0 0xc0 0xd0 * managed: 0x40 0xd0 * AP: 0x00 0x20 0x40 0xa0 0xb0 0xc0 0xd0 * AP/VLAN: 0x00 0x20 0x40 0xa0 0xb0 0xc0 0xd0 * mesh point: 0xb0 0xc0 0xd0 * P2P-client: 0x40 0xd0 * P2P-GO: 0x00 0x20 0x40 0xa0 0xb0 0xc0 0xd0 * P2P-device: 0x40 0xd0 software interface modes (can always be added): * monitor interface combinations are not supported HT Capability overrides: * MCS: ff ff ff ff ff ff ff ff ff ff * maximum A-MSDU length * supported channel width * short GI for 40 MHz * max A-MPDU length exponent * min MPDU start spacing Device supports TX status socket option. Device supports HT-IBSS. Device supports scan flush.